


Independent repair
Bosch Dishwasher Repair in Northern Virginia, DC & Maryland
Bosch dishwashers are quiet, and when one stops it usually stops in one of a few ways: water left in the tub with E24 on the display, an E15 that will not clear, dishes that come out cold and wet, or a panel that goes dark partway through a cycle. FixDaddy does Bosch dishwasher repair in homes and small businesses across Northern Virginia, Washington DC and the Maryland suburbs. This page covers the Bosch series we see, the faults that come up most, and what the visit looks like.
- $89 visit, credited to the repair
- 90-day parts & labor warranty
- Same-day most days
- Someone answers 24/7
What usually goes wrong
Bosch dishwasher faults, in the order we see them
- 1
Water left in the bottom of the tub, E24 or E25 on the display
Most probably
- Food, glass or a jar label stuck in the three-piece filter or under the drain pump cover
- Drain pump impeller jammed, or the pump motor dead
- Drain hose kinked behind the unit, or routed without its high loop so sink water runs back in
- A new garbage disposal with the knockout plug still in, or a clogged air gap at the sink
- 2
E15 shows, the drain pump runs and will not stop, nothing else works
Most probably
- Water in the base pan under the tub has lifted the float switch
- Door gasket, or the seal strip along the bottom of the door, letting water past
- A loose hose clamp, a cracked sump seal or a weeping inlet valve
- Suds from regular dish soap or too much detergent overflowing into the pan
- An AquaStop supply hose leaking inside its jacket, so it looks dry from outside
- 3
Dishes come out cold and wet, or the cycle runs for hours, sometimes with E09
Most probably
- The heater built into the heat pump (Bosch's name for the circulation pump) has failed
- The temperature sensor on the pump reading wrong, so the control never sees heat
- Scale from hard water coating the heater
- Rinse aid empty, or its dispenser cap cracked so it never dispenses
- 4
Panel dead or lights blinking, will not start, or stopped partway through a cycle
Most probably
- Door latch not closing its microswitch, so the control thinks the door is open
- Power module (the main control board) failed, or a relay on it burned
- Touch panel in the door failed
- Power cord or junction box overheated on a unit covered by the BSH recall
- Tripped breaker or GFCI outlet under the sink
- 5
Gritty film on the dishes, cloudy glasses, food still on the top rack
Most probably
- Spray arm holes packed with seeds and glass, or an arm cracked at the hub
- Filter not seated, so grit gets pumped back over the load
- Water never getting hot, so the detergent does not dissolve
- Water diverter stuck, so the top arm never gets its turn (Bosch flags its circuit as E05)
- Hard water leaving a mineral film that looks like poor washing
- 6
The door drops open on its own, slams down, or will not stay shut
Most probably
- Door springs broken on one or both sides
- The cables that carry the door on the hinges frayed or snapped
- Latch worn so the hook no longer holds
- A panel-ready unit with a heavy cabinet door and the spring tension set too light
- 7
Puddle on the floor in front of the dishwasher
Most probably
- Door gasket flattened or torn along the sides
- The seal strip at the bottom of the door worn through
- A cracked spray arm throwing water straight at the door
- Unit sitting out of level, so water pools against the front
Models and series
Which Bosch dishwashers we work on
Bosch sells its US dishwashers in five tiers. The 100 Series has stainless sides with a plastic tub floor and dries by condensation alone, so plastics come out damp by design. The 300 Series moves to an all-stainless tub, a third rack and AquaStop leak protection. The 500 Series adds AutoAir, where the door pops open at the end of the cycle to let the steam out. The 800 Series and the Benchmark line add CrystalDry, a zeolite module that gives off heat as it takes in moisture, plus the deeper MyWay third rack.
Underneath, every tier shares the same layout: the heater lives inside the circulation pump, a float in the base pan watches for leaks, and a three-piece filter sits in the sump. That is why the same faults turn up from the 100 Series to Benchmark: a heater that quits inside the pump, a drain pump that jams, door springs and cables that wear out, and a base-pan float that trips.
Parts
The Bosch dishwasher parts that fail most are the drain pump, the heat pump assembly with its built-in heater, the power module, the door latch, the door springs and cables, the door gasket, the inlet valve and the AquaStop hose. Filters, spray arms and rinse aid caps wear too, but they are simple swaps. We carry the common parts on the truck. Anything else is ordered by the model number on the sticker at the edge of the door; Bosch sells parts by model number through its own store, and the large US distributors stock most Bosch dishwasher parts and ship them the day they are ordered, so the technician comes back to fit it.
What is different inside a Bosch
Three things set a Bosch apart from the dishwasher you may have had before, and each one changes how it fails.
There is no exposed heating element in the tub. Water is heated by an element inside the circulation pump, and drying is done by condensation. When a Bosch stops heating, the fault is in that pump assembly, and Bosch's E09 code names it a heat pump internal heater fault.
There is a float in the pan under the tub. Any water that reaches the pan lifts it, the machine locks out and pumps, and E15 shows. That is good protection for your floor, and for the neighbor's ceiling in the condo towers we cover under dishwasher repair in Bethesda, but it means a small leak anywhere underneath stops the whole machine.
The filter comes apart in three pieces in the sump, and the drain pump sits under a round cover next to it. E22 means the filter is blocked, E25 that the pump is blocked or its cover is loose, and E24 that the drain path is, which can be as simple as the hose loop shown on our dishwasher repair page; the Bosch dishwasher error codes guide lists the rest. Top-control models have no display on the front, which is why many of them shine a red dot on the floor while running; when that dot is off and the dishes are still wet, the cycle never finished.
Hard water and your Bosch
The water across this area is hard. Hard water leaves minerals behind every time it is heated and dried, and a dishwasher heats and dries water several times a day.
On a Bosch that shows up in two places. Scale builds on the heater inside the pump, so it takes longer to reach temperature and eventually the element gives up. And a white haze settles on glasses, the same film our dishwasher repair in Alexandria page describes, which people often read as a washing fault when it is a water fault.
Rinse aid keeps the haze down, because it lets water run off the glass before it dries, and a dishwasher cleaner made for scale run once a month keeps the heater clean. If the haze wipes off with a cloth, the machine is fine. If the machine also runs long and the plates come out cold, the heater is the next thing we check.
What happens on the visit
Our visit fee is $89. The technician finds exactly what's wrong and gives you the full repair price at your home — no pressure. If you go ahead, the $89 counts toward the repair, and every repair has a 90-day warranty.
A built-in dishwasher has to come out from under the counter before most of it can be checked, so expect the technician to pull it, lay down floor protection first, and put shoe covers on at the door. You get the problem explained in plain English before anything is touched.
We book 2-hour arrival windows and the technician calls about 15 minutes before arriving. Someone answers the phone 24 hours a day, and same-day service is available most days. Payment is on completion, with the invoice sent by email or text.
Recent repairs
Bosch dishwasher repairs we did recently


Bosch dishwasher repair in Annandale
Partway through a cycle, the control panel on a Bosch dishwasher in Annandale went dead. Nothing on it responded, and the load was left sitting in standing water.…Partway through a cycle, the control panel on a Bosch dishwasher in Annandale went dead. Nothing on it responded, and the load was left sitting in standing water. Our technician was on-site to find out why the machine quit.

Bosch dishwasher repair in Vienna
In Vienna, a Bosch built-in dishwasher was failing on two counts: the wash cycle was not doing its job and the water was not draining out. Our technician…In Vienna, a Bosch built-in dishwasher was failing on two counts: the wash cycle was not doing its job and the water was not draining out. Our technician found both faults and repaired the machine.

Bosch dishwasher repair in Vienna
Our technician pulled a Bosch dishwasher out of its cabinet in Vienna and opened the door to diagnose it, with the tub and the spray arms exposed. A…Our technician pulled a Bosch dishwasher out of its cabinet in Vienna and opened the door to diagnose it, with the tub and the spray arms exposed. A built-in dishwasher has to come out from under the counter before most of it can be checked.

Bosch dishwasher repair in Oakton
A Bosch dishwasher in Oakton was pushing water back up into the kitchen sink instead of draining away. We get this call a lot in Oakton, and it…A Bosch dishwasher in Oakton was pushing water back up into the kitchen sink instead of draining away. We get this call a lot in Oakton, and it usually comes with the two related ones: water standing in the tub at the end of a cycle, and a leak at the drain line.
Guides
Bosch dishwasher guides
Some of these will save you the visit.
FAQ
Bosch dishwasher repair: frequently asked questions
My Bosch shows E24 and there is water in the bottom. Can I clear it myself?
Sometimes. Bosch's own advice is to pull the filter out of the sump and rinse it, check that the round pump cover is clicked down, and make sure the drain hose is not kinked. If the dishwasher drains into a new garbage disposal, ask whoever fitted it whether the knockout plug came out; if it did not, nothing you do at the machine will help. If E24 comes back after that, the pump or the hose route needs a technician.
What does E15 mean, and why does the pump keep running even with the door open?
E15 is Bosch's leak protection. A float in the tray under the tub has found water, so the machine refuses to start and keeps pumping. The water got there from somewhere: a seal, a clamp, a hose or the inlet valve. Emptying the tray clears the code until the leak fills it again, which is why we find the source rather than just reset it.
Do you repair Bosch dishwashers, or do I have to call Bosch?
You can call either. Bosch runs its own support line, and FixDaddy is an independent repair company that works on Bosch alongside the other brands. Our visit fee is $89. The technician finds exactly what's wrong and gives you the full repair price at your home — no pressure. If you go ahead, the $89 counts toward the repair.
Why does my Bosch leave plastic containers wet when the plates are dry?
Because it dries by condensation. There is no heating element in the tub; the stainless walls cool faster than the dishes, so the steam settles on the walls and runs off. Plastic holds little heat, so it stays damp. That is normal on the 100 and 300 Series. It is a fault only when plates and glasses come out wet too, or when the rinse aid is full and still nothing dries; then we look at the heater and the dispenser.
Is it worth repairing a Bosch that is eight or nine years old?
Usually, if the tub and the door are sound. Most of what fails on a Bosch is a pump, a module, a latch or a set of door springs, and all of those are replaceable. The technician gives you the full repair price at the house before touching anything, so you decide with the number in front of you. Every repair we do carries a 90-day parts-and-labor warranty.
Was my Bosch part of the power cord recall?
BSH, Bosch's parent company, recalled Bosch, Thermador, Gaggenau and some Kenmore Elite and Jenn-Air dishwashers because the power cord could overheat at the junction box. The units involved were built between 2008 and 2015. Check the model and serial number on the sticker at the edge of the door against the CPSC notice. The recall repair comes from BSH and is separate from anything we would quote.
How long does it take to get a Bosch part?
Common Bosch parts ride on the truck, so many repairs finish on the first visit. If yours needs something we do not carry, it is ordered by your model number; the large US parts distributors stock most Bosch dishwasher parts and ship them the day they are ordered, and the technician comes back to fit it. Same-day service is available most days for the first visit.
Bosch dishwasher acting up?
Someone answers now. The visit is $89, credited to the repair, and most days we are out the same day.
